מד זרימה מגנטי אינדוקטיבי - MIM

תחומים: 1.5-350 ...0.01-10 L/min

8 דגמים לתחומים מדידה שונים

מבנה: נירוסטה 316L

אלקטרודה : 316L

מתאים גם ל מדיה אגרסיבית

תצוגה מקומית צבעונית TFT בגודל : 1.4 "

לספיקה נמדדת+ מצטברת Total . ניתנת לתכנות לכל כיוון בהתאם להתקנה

זיהוי אוטומטי של צנרת ריקה

2 יציאות אנלוגית ניתנות לתכנות: 4-20mA או 0-20mA ,

0-10v

פולסים

מונה Totalizer , קוצב מנה Dosing Function

לחץ מקסימלי : 16BAR

טמפ' מקסימלית : 140C

אופציה: דגמים עם תצוגה ב GPM/ GPH

חיבורים : 2"-1/4"

דרגת אטימות : IP-67

The new flowmeter MIM was developed for measuring and monitoring smaller- and medium-sized flow of conductive liquids in pipes.

The device operates according to the electromagnetic measurement principle. According to Faraday’s Law of magnetic induction a voltage is induced in a conductor moving through a magnetic field. The electrically conductive measuring agent acts as the moved conductor. The voltage induced in the measuring agent is proportional to the flow velocity and is therefore a value for the volumetric flow.

The flowing media must have a minimum conductivity. The induced voltage is picked up by two sensing electrodes which are in contact with the measuring agent and sent to the measuring amplifier. The flow rate will be calculated based on the cross sectional area of the pipe. The measurement is not depending on the process liquid and its material properties such as density, viscosity and temperature.

Two given outputs can be set to be switch, analogue or frequnecy. Also a dosing function can be selected, where output 1 is set as switch NPN / PNP / PP and output 2 is set as control input.

How does a mag flow meter works?

A mag flow meter operates according to the electromagnetic measurement principle. According to Faraday’s Law of electromagnetic induction, a voltage is induced in a conductor moving through a magnetic field. The electrically conductive medium acts as the moved conductor. The voltage induced in the medium is proportional to the flow velocity and is therefore a value for the volumetric flow. The flowing media must have a minimum conductivity.

The induced voltage is picked up by two sensing electrodes, which are in contact with the medium, and sent to an amplifier.

The flow rate is calculated based on the cross sectional area of the pipe. The measurement is independent of the process liquid and its physcial properties such as density, viscosity and temperature